Texas Instruments MSP430 - Manual (Page 78)

MSP-TS430PM64A www.ti.com
Table B-16. MSP-TS430PM64A Bill of Materials
No. per
Pos. Ref Des Description DigiKey Part No. Comment
Board
1 C1, C2, 0 12pF, SMD0805 DNP
2 C3 0 2.2nF, SMD0805 DNP
3 C6, 1 10uF/10V, Tantal Size B 511-1463-2-ND
4 C4, C5 2 100nF, SMD0805 478-3351-2-ND
5 D1 1 green LED, SMD0805 P516TR-ND
DNP: Headers and
receptacles enclosed with
J1, J2, J3, SAM1029-16-NDSAM1213-
6 0 16-pin header, TH kit. Keep vias free of
J4 16-ND
solder.: Header:
Receptacle
J5, JP3,
JP4, JP5,
7 8 3-pin header, male, TH SAM1035-03-ND
JP6, JP7,
JP8, JP9
8 JP1, JP2 2 2-pin header, male, TH SAM1035-02-ND Place jumper on header
9 2 Jumper 15-38-1024-ND Place on: J6, J7
10 JTAG 1 14-pin connector, male, TH HRP14H-ND
DNP: Keep vias free of
11 BOOTST 0 10-pin connector, male, TH
solder
Micro Crystal MS1V-T1K
DNP: Keep vias free of
12 Q1 0 Crystal 32.768kHz, C(Load) =
solder
12.5pF
13 R3, R6 2 330 Ω , SMD0805 541-330ATR-ND
R1, R2, R5,
R7, R9, R10, DNP: R5, R7, R9, R10,
14 2 0 Ω , SMD0805 541-000ATR-ND
R11, R13, R11, R13, R14
R14
15 R4 1 47k Ω , SMD0805 541-47000ATR-ND
16 U1 1 Socket: IC51-0644-807 Manuf.: Yamaichi
17 PCB 1 78 x 75 mm 4 layers
Rubber Apply to corners at bottom
18 4 select appropriate
stand off side
DNP: Enclosed with kit
19 MSP430 2 MSP430F4152IPM
supplied by TI
78 Hardware SLAU278F – May 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated