Texas Instruments MSP430 - Manual (Page 82)

MSP-TS430RGC64USB www.ti.com
B.17 MSP-TS430RGC64USB
Due to the use of diodes in the power chain, the voltage on the MSP430F5xx device is approximately
0.3 V lower than is set by the debugging tool. Set the voltage in the IDE to 0.3 V higher than desired; for
example, to run the MCU at 3.0 V, set it to 3.3 V.
Figure B-33. MSP-TS430RGC64USB Target Socket Module, Schematic
82 Hardware SLAU278F – May 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated