Texas Instruments MSP430 - Manual (Page 38)

MSP-TS430L092 www.ti.com
Settings of the MSP-TS430L092 Target Socket
Figure B-4 shows the PCB layout of the MSP-TS430L092 target socket. The following pinning is
recommended:
• JP1 is write enable for the EPROM. If this is not set, the EPROM can only be read.
• JP2 and JP3 connect device supply with boost converter. They can be opened to measure device
current consumption. For default operation, they should be closed.
Figure B-4. MSP-TS430L092 Target Socket Module, PCB
38 Hardware SLAU278F – May 2009 – Revised December 2010
Submit Documentation Feedback
© 2009–2010, Texas Instruments Incorporated