Toshiba TECRA S1 - Manual (Page 173)

4.4 HDD 4 Replacement Procedures
TECRA S1 Maintenance Manual 4-25
3. Remove the HDD pack by pulling the HDD cover attached to the HDD pack.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble or
replace the HDD pack only if it failed.
4. Place the HDD pack on a flat surface (such as a desk), and remove the four M3x4
black flat-head screws.
5. Remove the HDD chassis.
6. Remove the HDD connector.
Figure 4-13 Removing the HDD chassis
CAUTION: Do not apply pressure to the top or bottom of the drive.