Toshiba TECRA S1 - Manual (Page 194)

4 Replacement Procedures 4.12 Top Cover with the Display Assembly
4-46 TECRA S1 Maintenance Manual
4.12 Top Cover with Display Assembly
Removing the Top Cover with the Display Assembly
Remove the display assembly with the top cover according to the following procedures and
Figures 4-29, 4-30, 4-31 and 4-32.
1. Turn the computer upside down, and remove two M2.5x6 black bind screws,
Figure 4-29 Removing the screws from the bottom of the computer
2. Restore the normal computer placement and open the display panel. Disconnect the
LCD/FL cable from CN3 on the system board.
3. Remove the wireless antenna cables from the guides (grooves) on the top cover.
4. Remove the display module.