Westell Technologies Versalink 327W - Manual (Page 119)

030-300500 Rev. A 119 October 2006
User Guide VersaLink™ Gateway (Model 327W)
13.5 Static NAT
If you select Services from the Configuration menu, the following screen will be displayed, showing the static
NAT button. Static NAT allows you to configure VersaLink to work with the special NAT services.
NOTE: When the Gateway is configured for Static NAT, any unsolicited packets arriving at the WAN would be
forwarded to this device. This feature is used in cases where the user wants to host a server for a specific application.
IMPORTANT: Single Static IP must be disabled (if it has been enabled previously) before you enable static NAT.
To disable Single Static IP, select Single Static IP from the Configuration menu. Next, click on the disable button,
and then click on OK in the pop-up screens to allow the Gateway to be reset. As explained in section 12.1 (Single
Static IP), you must reboot your computer after you enable or disable Single Static IP. After you have rebooted your
computer, return to static NAT configuration screen by selecting Services from the Configuration menu and
clicking on the static NAT button.