Westell Technologies Versalink 327W - Manual (Page 72)

030-300500 Rev. A 72 October 2006
User Guide VersaLink™ Gateway (Model 327W)
12.5.2 DHCP Configuration (Private LAN)
The following settings will be displayed if you select DHCP from the Advanced LAN menu.
DHCP Server
This setting allows VersaLink to automatically assign IP addresses to local devices
connected on the LAN. Westell advises setting this to enabled for the private LAN.
Off = DHCP Server is disabled
Private LAN = DHCP addresses will be saved into the Private LAN configuration.
Public LAN = DHCP addresses will be saved into the Public LAN configuration.
This option is only available if the Public LAN DHCP server is enabled.
NOTE: These addresses will be overwritten if the Internet Service Provider
supports dynamic setting of these values.
DHCP Start Address Factory Default = 192.168.1.15
This field displays the first IP address that the DHCP server will provide. The
DHCP Start Address must be within the IP address and lower than the DHCP End
Address. You may use any number from 0 to 254 in this address.
DHCP End Address Factory Default = 192.168.1.47
This field displays the last IP address that the DHCP server will provide. The
DHCP End Address must be within the IP address and higher than the DHCP Start
Address. You may use any number from 0 to 254 in this address.
DHCP Lease Time Factory Default = 01:00:00:00
Displays the amount of time the provided addresses will be valid, after which the
DHCP client will usually re-submit a request.
NOTE: DHCP Lease Time value must be greater than 10 seconds. Seconds must
be between 0 and 59, minutes must be between 0 and 59, and hours must be
between 0 and 23.