Westell Technologies Versalink 327W - Manual (Page 57)

030-300500 Rev. A 57 October 2006
User Guide VersaLink™ Gateway (Model 327W)
If you select Edit from the Security Level screen, the User Defined Firewall Rules screen will be displayed. This
screen allows you to change the security parameters on your Inbound and Outbound Firewall rules via the User
Defined Firewall Rules drop-down arrow. If you select Inbound, this will restrict inbound traffic from the WAN to
the LAN. Outbound restricts outbound traffic to the WAN from the LAN. To apply the new settings, click Apply in
the screen labeled User Defined Firewall Rules.
NOTE: Westell recommends that you do not change the settings in the User Defined Firewall Rules screen. If you
need to reset VersaLink to factory default settings, push the reset button on the rear of VersaLink.
The information displayed in the following screen depends upon the Firewall security setting you have selected. If
you selected “None” in the preceding Firewall Security Level screen, no values will be displayed in the following
User Defined Firewall Rules screen.
If you clicked Apply in the User Define Firewall Rules screen, the following pop-up screen will be displayed.
Click on OK if you want your new firewall setting to take effect. If you click Cancel, your new firewall settings will
not take effect.
NOTE: The information displayed in this screen
depends on the level of security you have selected.