Westell Technologies Versalink 327W User Manual
Page 97
030-300500 Rev. A
97
October 2006
User Guide
VersaLink™ Gateway (Model 327W)
12.6.5 Configuring VersaLink’s Protocol Settings for Bridge Mode
To configure VersaLink’s protocol settings for Bridge mode, select WAN from the Advanced WAN menu. The WAN
Configuration screen will be displayed. Next, click on the edit button adjacent to any of the existing ‘Enabled’ VC
(Virtual Connection) protocols. The VC1 Configuration screen will be displayed.
NOTE: The protocol status must display “Enable” to allow edits to its VC configuration.
If you select Bridge protocol from the Protocol drop-down arrow, the following screen will be displayed. Select a
mode from the options listed in the Mode drop-down arrow, under VC 1 – Bridge Settings.