Westell Technologies Versalink 327W - Manual (Page 77)

030-300500 Rev. A 77 October 2006
User Guide VersaLink™ Gateway (Model 327W)
12.5.5 Private LAN Configuration – Configuring NAT
The following settings will be displayed if you select Private LAN from the Advanced LAN menu. (Private LAN
is the default configuration for this VersaLink.)
NOTE: Private LAN allows you to set up a network behind VersaLink.
If you change the settings in this screen, click save. If you click reset, the changes will not take effect.
If you made changes and clicked on save, the following pop-up screen will be displayed. Click on OK. This will
save your Private LAN Configuration settings. If you click Cancel, your new settings will not take effect.
Private LAN DHCP Server Enable Default = CHECKED
If this box is CHECKED, it enables DHCP addresses to be served from
the Private LAN pool.
Private LAN Enable Default = CHECKED
If this box is CHECKED, it enables the addresses from the Private LAN to
use the NAT interface.
Modem IP Address Displays VersaLink’s IP address