Welch Allyn PROPAQ CS User Manual

Page 24

Advertising

Functional verification

Welch Allyn Propaq CS Vital Signs Monitor

15. Press ECG/RESP > MORE. Then press CHANGE to select the four HR/PR TONE

levels. Verify that the tone volume changes and goes off when turned OFF. Set the
volume to LOW or OFF.

16. Press HOME

to return to the Main Menu.

17. Software versions 3.6x and greater: Press SETUP > MORE > MORE > SERVICE >

YES > MORE > MORE > SETTINGS > ALL ALARMS. Verify alarm status displays
“TURNING OFF ALL AUDIBLE VITAL SIGNS ALARMS”, “ARE YOU SURE?”, YES or
NO.

18. Software versions 3.6x and greater: Press HOME

to return to the Main Menu.

19. Press SETUP > MORE > MORE and check that the displayed time and date are

correct.

Table 5. Keystrokes and monitor responses—Software versions 3.6x and greater

Press

Result

SETUP

Changes the menu.

ALARMS

Changes the display to ALARM STATUS.

4 MIN SUSPND (on menu at bottom of screen)

4 MIN SUSPND changes to RESUME.

Silence/Reset button

(software version 3.6sx and

greater) or Alarm Suspend/Resume (software version
3.5x and earlier).

RESUME changes to 4 MIN SUSPND.

LIMITS

Changes display to ALARM Limits.

NEXT PARAMETER

Moves cursor block down - Next block in parameter limits

NEXT SETTING

Moves cursor block between upper and lower setting.

Home button

Returns to the Main Menu.

NIBP Start/Stop button

twice

Starts/stops the NIBP pump.

Table 6. Keystrokes and monitor responses—All other software versions

Press

Result

SETUP

Changes the menu.

ALARMS

Changes the display to ALARM STATUS.

SUSPEND (on menu at bottom of screen)

SUSPEND changes to RESUME.

Silence/Reset button

(software version 3.6sx and

greater) or Alarm Suspend/Resume (software version
3.5x and earlier).

Toggles Suspend/Resume alarms.

ALL ALARMS (then press NO)

Changes display. Turn ALL OFF. Are You Sure? Y or N.