ZyXEL Communications ZyXEL ZyWALL P1 - Manual (Page 252)

ZyWALL P1 User’s Guide
Chapter 17 Firmware and Configuration File Maintenance 251
Figure 135 FTP Session Example
17.3.2 GUI-based FTP Clients
The following table describes some of the commands that you may see in GUI-based FTP
clients.
17.3.3 File Maintenance Over WAN
TFTP and FTP over the WAN will not work when:
1 The firewall is active (turn the firewall off or create a firewall rule to allow access from
the WAN).
2 You have disabled Telnet service in the Remote Management screen.
3 The IP you entered in the Secured Client IP field in the Remote Management screen
does not match the client IP. If it does not match, the ZyWALL will disconnect the
session immediately.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
Table 95 General Commands for GUI-based FTP Clients
COMMAND DESCRIPTION
Host Address Enter the address of the host server.
Login Type Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or
service administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer Type Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode
Initial Remote Directory Specify the default remote directory (path).
Initial Local Directory Specify the default local directory (path).