ZyXEL Communications ZyXEL ZyWALL P1 - Manual (Page 43)

ZyWALL P1 User’s Guide
42 Chapter 2 Introducing the Web Configurator
2.3.1 Procedure to Use the Reset Button
Make sure the PWR LED is on (not blinking) before you begin this procedure.
1 Press the RESET button in for about 10 seconds and release it. When the PWR LED
starts to blink, the defaults have been restored and the ZyWALL restarts. Otherwise, go to
step
2 .
2 Turn the ZyWALL off.
3 While pressing the RESET button, turn the ZyWALL on.
4 Continue to hold the RESET button. The PWR LED will begin to blink. This indicates
that the defaults have been restored. Release the RESET button.
5 Wait for the ZyWALL to finish restarting before accessing again.
2.4 Navigating the Web Configurator
The following summarizes how to navigate the web configurator from the HOME screen.
Note: Follow the instructions you see in the HOME screen or click the icon
(located in the top right corner of most screens) to view online help.
2.4.1 The HOME Screen
The following screen shows the HOME screen.