ZyXEL Communications ZyXEL ZyWALL P1 - Manual (Page 362)

ZyWALL P1 User’s Guide
Appendix N Log Descriptions 361
Log Commands
Go to the command interpreter interface. Appendix I on page 329 explains how to access and
use the commands.
Configuring What You Want the ZyWALL to Log
1 Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the ZyWALL is to record.
2 Use sys logs category to view a list of the log categories (this display varies by
model).
Figure 205 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 206 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
SIG Signature
NONCE Nonce
NOTFY Notification
DEL Delete
VID Vendor ID
Table 142 RFC-2408 ISAKMP Payload Types (continued)
LOG DISPLAY PAYLOAD TYPE
ras> sys logs category
8021x access attack display
error icmp ike ipsec
javablocked mten packetfilter ppp
cdr pki tls remote
tcpreset traffic upnp urlblocked
urlforward wireless
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]