Table 55 mvr – ZyXEL Communications LAYER 3 ES-3124 User Manual

Page 180

Advertising
background image

ES-3124 User’s Guide

178

Chapter 22 Multicast

The following table describes the related labels in this screen.

Table 55 MVR

LABEL

DESCRIPTION

Active

Select this check box to enable MVR to allow one single multicast VLAN to be

shared among different subscriber VLANs on the network.

Name

Enter a descriptive name (up to 32 printable ASCII characters) for identification

purposes.

Multicast VLAN

ID

Enter the VLAN ID (1 to 4094) of the multicast VLAN.

802.1p Priority

Select a priority level (0-7) with which the switch replaces the priority in outgoing

IGMP control packets (belonging to this multicast VLAN).

Mode

Specify the MVR mode on the switch. Choices are Dynamic and Compatible.
Select Dynamic to send IGMP reports to all MVR source ports in the multicast

VLAN.
Select Compatible to set the switch not to send IGMP reports.

Port

This field displays the port number on the switch.

*

Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this

row first to set the common settings and then make adjustments on a port-by-port

basis.

Note: Changes in this row are copied to all the ports as soon as you

make them.

Source Port

Select this option to set this port as the MVR source port that sends and receives

multicast traffic. All source ports must belong to a single multicast VLAN.

Receiver Port

Select this option to set this port as a receiver port that only receives multicast

traffic.

None

Select this option to set the port not to participate in MVR. No MVR multicast traffic

is sent or received on this port.

Tagging

Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames

transmitted.

Add

Click Add to save your changes to the switch’s run-time memory. The switch loses

these changes if it is turned off or loses power, so use the Save link on the top

navigation panel to save your changes to the non-volatile memory when you are

done configuring.

Cancel Click

Cancel to reset the fields.

VLAN

This field displays the multicast VLAN ID.

Active

This field displays whether the multicast group is enabled or not.

Name

This field displays the descriptive name for this setting.

Mode

This field displays the MVR mode.

Source Port

This field displays the source port number(s).

Receiver Port

This field displays the receiver port number(s).

802.1p

This field displays the priority level.

Delete

To delete a multicast VLAN(s), select the rule(s) that you want to remove in the

Delete column, then click the Delete button.

Cancel

Click Cancel to clear the Delete check boxes.

Advertising