ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 286)

ES-3124 User’s Guide
284 Chapter 36 Configuration Mode Commands
where
An example is shown next.
• Create a filtering rule called “filter1”.
• Drop packets coming from and going to MAC address 00:12:00:12:00:12 on VLAN.
36.8 Enabling Trunking
To create and enable a trunk, enter trunk followed by the ports which you want to group and
press [ENTER]
.
Syntax:
trunk <T1|T2|T3|T4|T5|T6>
trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
trunk <T1|T2|T3|T4|T5|T6> lacp
where
An example is shown next.
• Create trunk 1 on the switch.
name <name> = Names the filtering rule.
mac <mac-addr> = Specifies the MAC address you want to filter.
vlan <vlan-id> = Specifies which VLAN this rule applies to.
drop <src/dst/both> = Selects the behavior of the rule.
• src - drop packets coming from the specified
MAC address
• dst- drop packets going to the specified MAC
address
• both - drop packets coming from or going to the
specified MAC address
ras(config)# mac-filter name filter 1
ras(config)# mac-filter name filter 1 mac 00:12:00:12:00:12 vlan 1 drop both
<T1|T2|T3|T4|T5|T6> = Enables the trunk.
<T1|T2|T3|T4|T5|T6>
interface <port-list> = Places ports in the trunk.
<T1|T2|T3|T4|T5|T6> lacp = Enables LACP in the trunk.