ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 282)

ES-3124 User’s Guide
280 Chapter 36 Configuration Mode Commands
where
An example is shown next.
• Enable the IP route with the IP address of 192.168.11.1 and subnet mask of
255.255.255.0. This ip route must have already been created and made inactive prior to
re-enable command being applied.
36.4.4 Other Examples of no Commands
In some cases the no command can disable a feature, disable an option of a feature or disable a
feature on a port by port basis.
36.4.4.1 no trunk
Syntax:
no trunk <T1|T2|T3|T4|T5|T6>
no trunk <T1|T2|T3|T4|T5|T6> lacp
no trunk <T1|T2|T3|T4|T5|T6> interface <port-list>
where
An example is shown next.
• Disable trunk one (T1).
• Disable LAPC on trunk three (T3).
• Remove ports one, three, four and five from trunk two (T2).
<ip> <mask> inactive = Re-enables an ip route with the specified IP address and
subnet mask.
ras(config)# no ip route 192.168.11.1 255.255.255.0 inactive
<T1|T2|T3|T4|T5|T6> = Disables the trunk group.
<T1|T2|T3|T4|T5|T6>
lacp = Disables LACP in the trunk group.
<T1|T2|T3|T4|T5|T6>
interface <port-list> = Removes ports from the trunk group.
ras(config)# no trunk T1
ras(config)# no trunk T3 lacp
ras(config)# no trunk T2 interface 1,3-5