ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 191)

ES-3124 User’s Guide
Chapter 25 DiffServ Code Point 189
The following table describes the related labels you use to create a static route.
25.3 Configure DSCP Setting
Use this screen to convert DSCP priority to IEEE 802.1p priority. Click IP Application,
DiffServ, DSCP in the navigation panel to display the screen as shown.
Table 59 Static Routing
LABEL DESCRIPTION
DSCP Setting Click DSCP Map to open the screen where you can set up the mapping between
source DSCP priority and IEEE 802.1p priority.
Active This field allows you to activate/deactivate DiffServ on the switch.
Port This read-only index number indicates which port you are activating.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active This allows you to activate DiffServ on a per port basis.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields.