ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 262)

ES-3124 User’s Guide
260 Chapter 34 Introducing Commands
pvid <1-4094> The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
13
ingress-check Enables the device to discard
incoming frames for VLANs that
are not included in a port member
set.
13
gvrp Enables this function to permit
VLAN groups beyond the local
switch.
13
frame-type
<all|tagged|unt
agged>
Choose to accept both tagged and
untagged incoming frames, just
tagged incoming frames or just
untagged incoming frames on a
port.
13
name <port-
name-string>
Sets a name for the port(s). Enter
a descriptive name (up to nine
printable ASCII characters).
13
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
switch.
13
flow-control Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
13
bandwidth-limit Enables ingress (pir), cir and
egress limits on the port(s).
13
cir Enables the guaranteed bandwidth
limits for incoming traffic on the
port(s).
13
cir <Kbps> Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir <Kbps> Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
egress Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13
egress <Kbps> Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
broadcast-limit Enables broadcast storm control
limit on the switch.
13
<pkt/s> Sets how many broadcast packets
the interface receives per second.
13
Table 85 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE