ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 83)

ES-3124 User’s Guide
Chapter 7 Basic Setting 81
7.7 Port Setup
Use this screen to configure switch port settings. Click Basic Setting and then Port Setup in
the navigation panel to enter the port configuration screen.
Full-duplex mode operation only applies to point-to-point access (for example, when attaching
the switch to a workstation, server, or another switch). When connecting to hubs, use a
standard cascaded connection set at half-duplex operation.
Auto-negotiation regulates the speed and duplex of each port, based on the capability of both
devices. When auto-negotiation is turned on, an Ethernet port on the ZyXEL switch negotiates
with the peer automatically to determine the connection speed and duplex mode. If the peer
Ethernet port does not support auto-negotiation or turns off this feature, the ZyXEL switch
determines the connection speed by detecting the signal on the cable and using half duplex
mode. When the ZyXEL switch’s auto-negotiation is turned off, an Ethernet port uses the
preconfigured speed and duplex mode when making a connection, thus requiring you to make
sure that the settings of the peer Ethernet port are the same in order to connect.
IP Subnet
Mask
Enter the IP subnet mask in dotted decimal notation.
VID Type the VLAN group identification number.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Manageable Select this option to allow the switch to be managed using this specified IP address.
Add Click Add to save the new rule to the switch’s run-time memory. It then displays in the
summary table at the bottom of the screen.
Cancel Click Cancel to reset the fields.
Index This field displays the index number of an entry. Click an index number to edit the rule.
IP Address This field displays the IP address.
Subnet Mask This field displays the subnet mask.
VID This field displays the VLAN identification number of the network.
Default
Gateway
This field displays the IP address of the default outgoing gateway.
Manageable This field displays whether the switch can be managed using the specified IP address.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 11 IP Setup (continued)
LABEL DESCRIPTION