ZyXEL Communications LAYER 3 ES-3124 - Manual (Page 253)

ES-3124 User’s Guide
Chapter 34 Introducing Commands 251
fe-spq
<q0|q1|..|
q7>
Sets the switch to use SPQ to
service the subsequent queue(s)
after and including the specified
queue for the 10/100 Mbps
Ethernet ports.
13
ip route <ip> <mask>
<next-hop-ip>
Creates a static route. 13
<ip> <mask>
<next-hop-ip>
[metric
<metric>]
[name <name>]
[inactive]
Sets the metric of a static route or
deactivates a static route.
13
name-server <ip> Sets the IP address of a domain
name server.
13
address default-
gateway
<ip> Sets the default gateway's IP
address for the out-of-band
management port.
13
address <ip> <mask> Sets the IP address and subnet
mask of the out-of-band
management port.
13
mac-
forward
name <name> mac
<mac-addr> vlan
<vlan-id>
interface
<interface-id>
Configures a static MAC address
forwarding rule.
13
inactive Disables a static MAC address
forwarding rule.
13
mac-filter name <name> mac
<mac-addr> vlan
<vlan-id> drop
<src/dst/both>
Configures a static MAC address
port filtering rule.
13
inactive Disables a static MAC address
port filtering rule.
13
mirror-
port
Enables port mirroring. 13
<port-num> Sets the monitor port (the port to
which traffic is copied for
analysis).
13
lacp Enables Link Aggregation Control
Protocol (LACP).
13
system-priority <1-65535> Sets the priority of an active port
using LACP.
13
trunk <T1|T2|T3|T4|T5|
T6>
Activates a trunk group. 13
<T1|T2|T3|T4|T5|
T6> lacp
Enables LACP for a trunk group. 13
Table 84 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION PRIVILEGE