AASTRA 630d for Aastra IntelliGate User Guide EN - Manual (Page 45)

Personalizing Your Phone
Aastra 630d 45
e
u
d
-10
95
/1
.0
–
I7
.8
–
07
.2
0
0
9
■ Activating range alarm and system busy beep
You want to set the system parameters with your cordless phone.
The Range alarm indicates that the connection between your phone and the system is weak.
You can set the phone so that you receive a warning signal if you leave the coverage area
• You are making a call and are getting near the limit of the radio area: A warning signal
sounds in the loudspeaker and the LED indicator is flashing red. If you leave the radio area,
the call is disconnected.
• The phone is in standby mode and you leave the radio area (only for phones on an alarm sys-
tem, see chapter
"Alarm" , page 61 ): The phone warns you by means of a continuous ringing.
After acknowledging this continuous ringing, it will be again triggered after approx. one
minute.
The System busy beep tells you that the system is overloaded – you need to wait until the system
is available again.
<PIN>
Enter the PIN and confirm with the Ok softkey.
Free Scroll to Free and confirm with the Select softkey.
➔ The phone is unlocked.
➔ To lock all your phones, execute the *33* <PIN> # function code (see
"User’s Guide */# Procedures").
Press the navigation key to the right or the Menu softkey.
Settings
Scroll to Settings and press the Select softkey.
General
Scroll to General and press the Select softkey.
<Setting>
Select the setting you want and switch on or off with the Select softkey.
eud-1095_en.book Page 45 Monday, July 13, 2009 1:56 PM