Trigger procedure, Alarm – AASTRA 630d for Aastra IntelliGate User Guide EN User Manual
Page 64
Alarm
64
Aastra 630d
e
u
d
-10
95
/1
.0
–
I7
.8
–
07
.2
0
0
9
■ Trigger procedure
Alarm message sequence
Signalling on the phone
User interaction
Detection phase:
The phone detects an alarm
situation. The detection
duration starts to run (see
Detection duration
setting).
No signalling
No interaction
Pre-alarm phase:
The phone signals a
pre-alarm. Alarm delay starts
to run (see
Alarm cancellation
delay
setting).
• Progressive signalling ring.
Rings for several seconds
and repeats itself. This ring-
ing cannot be switched off.
• Vibracall, if activated.
• LED indicator flashes fast
and red.
Pressing any key resets the
alarm. The alarm message is
not sent to the alarm system.
Alarm phase:
The phone sends the alarm
to the alarm system.
Depending on the configura-
tion of the alarm system an
alarm melody sounds. Rings
until the alarm system
acknowledges receipt of the
alarm message or the set
ringing duration (see
Alarm
confirmation time
) expires.
Pressing any key resets the
alarm.
The subsequent procedure depends on how the alarm system is configured. Contact your sys-
tem administrator for more information.
eud-1095_en.book Page 64 Monday, July 13, 2009 1:56 PM