AASTRA 630d for Aastra IntelliGate User Guide EN - Manual (Page 74)

Installation and commissioning
74 Aastra 630d
e
u
d
-10
95
/1
.0
–
I7
.8
–
07
.2
0
0
9
Connecting a cordless phone
■ Connecting the charging bay
Before connecting the charging bay, you must remove the two lateral guides in the charging
bay. They are easy to lift on the inside edge using a fingernail or a paper clip. You can remove
these plastic guides by pushing a suitable screwdriver into the slits on the bottom of the
charger.
1. Plug the cable connector into the socket on the underside of the charging station.
2. Feed the cable through the strain relief provided.
3. Plug the plug-in power adapter into an available socket outlet.
■ Power supply / Plug-in power supply unit
The power supply unit is rated for 100 V to 240 V AC (50-60 Hz). It is supplied with four inter-
changeable adapters, which means it can be used more or less worldwide. Where necessary, fit
the standard adapter head for your country to the power supply unit. As the plug-in power sup-
ply unit comes in two variants, the assembly differs slightly:
• Variant 1: Set the switch on the power supply unit to OPEN and slide the existing adapter
head upwards and out. Next fit the new adapter head to the power supply unit and lock it
into place using the switch (LOCK).
• Variant 2: First remove any adapter head that may already be fitted by pressing OPEN. Next
fit the new adapter head onto the power supply unit at a slight angle with the end marked
TOP at the top. Press it down until it clicks into place.
■ Software
New device software can simply be updated during operation using automatic firmware
updates, reducing maintenance costs as a result.
Note:
Plug designs vary from country to country.
eud-1095_en.book Page 74 Monday, July 13, 2009 1:56 PM