Grain Systems Tanks PNEG-1912 - Manual (Page 28)

28 PNEG-1912 6', 7' and 9' Tall BFT Series and GHT Series
7. Roof
Sealed Roof Panels Installation
NOTE: The roof and sidewall ladders are centered on a roof panel. Be sure to apply two (2) strips of
caulking on either side of bolt holes at the seams. Roof panel edges allow for the roof to be assembled in
either the clockwise or counterclockwise manner. (See roof sheet overlap detail
on Page 29 .) Be sure to
lap sheets in the same manner around the entire tank.
Figure 7A
On bins that will be equipped with a pneumatic fill system (See Page 72) , the two (2) roof panels with fill
hole and exhaust hole must be located opposite each other on the Bulk Feed Tank. The peak ring may
now be installed.