Raising bin, Chapter 13 raising bin, Raising bin to set on foundation – Grain Systems Tanks PNEG-1912 User Manual
Page 67: Preparing tank for lifting upright
PNEG-1912 6', 7' and 9' Tall BFT Series and GHT Series
67
13. Raising Bin
Raising Bin to Set on Foundation
Preparing Tank for Lifting Upright
Just before standing the tank upright, peel protective mask off the decal while it is easy to reach. Mask
may become difficult to remove if left exposed to sunlight.
Check for all possible overhead obstructions, power line, etc., BEFORE standing the tank on
the foundation.
To prevent damage to Legs when raising tank, brace them with 2" x 4 " (50mm x 100mm) pieces of wood
as shown in the illustruction. See the chart for the correct length.
Some tanks may be built on the side and raised upward. For some taller tanks (9 rings and taller) it is
recommended the sidewalls be assembled using bin jacks and the final lifting be done with a crane.
In any case, proper precautions with rigging, lifting, or raising procudures should be followed to ensure
that personal safety is not compromised and the tank is not damaged.
Figure 13A
Bin Size
2" x 4" Length
6' Diameter (1829 mm)
51-3/8" (1305 mm)
7' Diameter (2134 mm)
59-7/8" (1521 mm)
9' Diameter (2743 mm)
52-1/8" (1324 mm)
Do not raise tank near power lines. Electrocution could occur if the tank came into
contact with live power lines.
WARNING