Grain Systems Tanks PNEG-1912 - Manual (Page 47)

9. Safety Cage
PNEG-1912 6', 7' and 9' Tall BFT Series and GHT Series 47
24"-48" Safety Cage Bell Section
Attach the vertical supports to the hoop half assembly from the final safety cage installation using
5/16" x 3/4" bolts and nuts with the head of the bolt to the inside of the safety cage. Assemble the special
bell hoop halves and attach to the other end of the vertical supports. The vertical supports must be bent
at the flat area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as
shown
in Figure 10A on Page 48 . Once the safety cage brackets are installed, attach the bell safety cage
hoop half assembly to the safety cage brackets. Tighten bolts as you go.
Figure 9H