Grain Systems Tanks PNEG-4135 - Manual (Page 127)

Chapter 7: Roof Assembly
NOTE: Ensure that the orientation of the roof panel clip is correct, roof panel holes facing the roof
and the notch in the roof panel clip is facing the right-hand roof rafter.
3. Tighten all hardware to the recommended torque specifications only after the roof panels are
installed. See Bolt Torque Specifications, page 26 .
Figure 7-39 Roof panel clip
A Left-hand roof rafter (CTR-0236 and CTR-
0239) D 1/2 x 1-3/4 in. flange bolt (S-10252)
B Roof panel clip (CTR-0346) E 1/2 in. flange nut (S-10253)
C Right-hand roof rafter (CTR-0236 and CTR-
0239)
After You Finish
Repeat this procedure for the remaining roof panel clips.
Pneg-4135 135 Ft Diameter 40-Series Bin 127