Grain Systems Tanks PNEG-4135 - Manual (Page 26)

Chapter 3: Hardware Requirements
Table 3-1 Hardware for 3-Post Sidewall Sheets on Bins that are 135 Ft in Diameter (cont'd.)
Gauge Horizontal Seam Vertical Seam Stiffener to Sidewall Overlap Seam
8 3/8-1 (22) 3/8-1 (48) 3/8-1.5 (12) 3/8-1.5 (2)
6 3/8-1.5 (22) 3/8-1.5 (48) 3/8-1.5 (12) 3/8-1.5 (2)
5 3/8-1.5 (22) 3/8-1.5 (48) 3/8-1.5 (12) 3/8-1.5 (2)
11L 3/8-1.5 (22) 3/8-1.5 (48) 3/8-1.5 (12) 3/8-1.5 (2)
10L 3/8-1.5 (22) 3/8-1.5 (48) 3/8-1.5 (12) 3/8-1.5 (2)
9L 3/8-1.5 (24) 7/16-2.5 (48) 3/8-1.5 (24) 3/8-2 (6)
8L 3/8-1.5 (24) 7/16-2.5 (48) 3/8-1.5 (24) 3/8-2 (6)
6LF 7/16-2 (20) 7/16-2.5 (72) 3/8-2 (24) 7/16-2 (10)
Bolt Torque Specifications
The specification torque table below will help the installer determine how tight a specific bolt must be. A
bolt that has been over tightened can be just as dangerous as one that hasn't been tightened enough.
IMPORTANT: Bolts should not be tightened in excess of the torque specifications chart listed below.
Bolt Minimum Torque Maximum Torque
Sealing Joints
(joints with seal-
ing washers)
Structural Joints
(joints without
any sealing
washers)
Sealing Joints
(joints with seal-
ing washers)
Structural Joints
(joints without
any sealing
washers)
ft-lb N-m ft-lb N-m ft-lb N-m ft-lb N-m
5/16-18 JS Gr 8 with seal 20 27 — — 25 34 — —
3/8 -16 JS Gr 8 with seal 30 41 — — 35 47 — —
7/16-14 JS Gr 8 with seal 50 68 — — 60 81 — —
3/8–16 YDP Gr 8 flanged — — 40 54 — — 45 61
7/16–14 YDP Gr 8 flanged — — 65 88 — — 75 101
1/2-13 YDP Gr 8 flanged — — 100 135 — — 115 155
26 Pneg-4135 135 Ft Diameter 40-Series Bin