Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 19)

PNEG-1435 6", 8" & 10" Utility & Bulk Augers 19
4. ASSEMBLY & INSTALLATION
Install the Truss Support
Note: For Bulk Tank Augers Only.
1. Begin by placing the Truss Support on the top side of the Auger Tube. Position the Truss
Support Half Band below the Truss Support and align the holes. Attach together using
appropriate hex bolt and Nylock nut. Do not tighten the nuts down until the proper distance
has been determined for the desired angle
(See Chart) and (Figure 4F) .
Figure 4F
Bolts (See Chart)
Truss Support
Auger Tube
Truss Support Band
Nylock Nut