Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 26)

26 PNEG-1435 6", 8" & 10" Utility & Bulk Augers
4. ASSEMBLY & INSTALLATION
Installing the Motor Mount Plate
1. Secure one (1) of the motor mount adjustment nuts and one (1) the motor mount adjustment
washers approximately 3/4 of the way down the motor mount adjuster’s threaded shaft.
2. Once the nut and washer is secure, slip the Motor Mount Plate over the adjuster and align
the pivot holes with the pivot tube (See Figure 4O) .
Figure 4O
3. Slide the Motor Mount Pivot Rod through the pivot tube on the Discharge Tube.
4. When the pivot rod begins to extend through the pivot tube install the spacers, BETWEEN
the Back Plate and the inner face of the Motor Mount Plate (See Figure 4P) .
Figure 4P
Note: The number of spacers will vary between each size of unloader.
Cotter Pin
Motor Mount Adjustment
Nut & Washer
Spacers
Pivot Tube
Motor Mount Adjustment Shaft
Pivot Holes
Motor Mount Pivot Rod
Motor Mount Plate
Cotter Pin
Spacers
Motor Mount Plate
Pivot Rod