Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 30)

30 PNEG-1435 6", 8" & 10" Utility & Bulk Augers
4. ASSEMBLY & INSTALLATION
Installing the Motor (Not Provided)
1. Attach the Motor to the Motor Mount Plate using appropriate bolts, lock washers, and hex
nuts (See Chart) .
2. Install pulley onto motor shaft making sure that it is aligned with the flight pulley. It may be
necessary to move spacers to gain shaft alignment (See Figure 4T) .
Figure 4T
Installing the Belts
1. Place the belts onto the pulleys.
2. First screw the lower Motor Mount Adjustment Nut upward, raising the Motor Mount Plate,
putting tension on the belts.
3. Once the desired tension is reached tighten the Upper Motor Mount Adjustment Nut down
onto the Motor Mount Plate locking it into place.
Motor Bolt Chart
Motor Size Hex Bolt Size Qty
56
143T
145T 5/16" x 1-1/4" - 18 4
182T
184T
213T
215T
3/8" x 1-1/4" - 16 4
254T
256T
1/2" x 1-3/4" - 13 4
Cotter Pin
Motor Mount Plate
Flight Pulleys
Spacers