Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 27)

PNEG-1435 6", 8" & 10" Utility & Bulk Augers 27
4. ASSEMBLY & INSTALLATION
Installing the Belt Guard Brackets
1. Align the holes on the Bearing Plate with the slots on the Belt Guard Mounting Brackets.
2. Secure the Brackets with proper bolts, flat washers, and Serrated Flange Nuts
(See Chart) and (Figure 4Q) .
Figure 4Q
Note: DO NOT tighten the bolts completely. The brackets will need to be rotated to align
the slot in the Belt Guard with the shafts on the motor and flight.
Bearing Bolts
6'' & 8'' 5/16'' x 1'' - 18 Hex Bolts
10'' 3/8'' x 1-1/4'' - 16 Hex Bolts
[ (See Chart) for Bolt Sizes] Belt Guard Mounting Bracket
Flat Washer
Bearing Plate
Serrated Flange Nuts