Installing the belt guard, Assembly & installation – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 User Manual
Page 31
PNEG-1435 6", 8" & 10" Utility & Bulk Augers
31
4. ASSEMBLY & INSTALLATION
Installing the Belt Guard
1. With the belts properly tensioned remove the bottom Belt Guard cover and slip Belt Guard
down over motor shaft.
2. Bolt the Belt Guard to the Belt Guard Mounting Brackets, the brackets should still be loose
at this time.
3. Align the motor shaft and the Flight Drive Shaft in the Belt Guard’s slot, making sure that
the Belt Guard DOES NOT contact either pulley, and tighten down the Belt Guard Mounting
Brackets to the Bearing Plate
.
Figure 4U
4. Once the brackets are tightened slide the bottom cover back into place and secure with
supplied bolt.
Belt Guard Mounting Brackets
Bottom Belt Guard Cover
Motor Mount Plate
Motor Mount Adjustment Nut
Belt Guard
Bolts