Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 35)

PNEG-1435 6", 8" & 10" Utility & Bulk Augers 35
6. STARTUP
NEVER operate augers empty for any length of time as excessive wear will result.
8. Do not stop or start augers under load, especially before the flight and tube become well
polished, as this may cause the auger to “lockup”.
Excessive wear will result if auger is run at speeds in excess of what is recommended.
9. Do not run auger at to slow speed, this will load up or over load the auger. An loading up of
the auger will cause the motor to over load and a higher torque will be required to turn the
auger, which in turn may cause damage to the auger.
CAUTION
CAUTION