Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 21)

PNEG-1435 6", 8" & 10" Utility & Bulk Augers 21
4. ASSEMBLY & INSTALLATION
3. Attach the Intake Guard to the Tube using the proper hex bolts and Nylock nuts through
the half bands that are welded to the Intake Guard (See Chart) and (Figure 4I) .
Figure 4I
4. Place Intake Guard Half Band above the lower half band on the Intake Guard and attach
using proper hex bolts and Nylock nuts (See Chart) and (Figure 4J) .
Figure 4J
Intake Guard Bolts
6" 5/16'' -18 x 1-3/4'' GR5 Hex Bolt
8" 5/16'' -18 x 1-3/4'' GR5 Hex Bolt
10" 3/8'' -16 x 1-1/2'' GR5 Hex Bolt
Intake Guard Half Band
Bolts (See Chart)
Intake Guard Half Band
Bolts & Nylock Nuts
(See Chart)