Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1435 - Manual (Page 28)

28 PNEG-1435 6", 8" & 10" Utility & Bulk Augers
4. ASSEMBLY & INSTALLATION
Installing the Lock Collar
1. Slide the Lock Collar over the Drive Shaft, positioning it against the bearing. Do not tighten
the lock collar at this time as it will be tightened later in the assembly (See Figure 4R) .
Figure 4R
Installing the Pulley
1. Place and position the key into the keyway located on the Drive Shaft.
2. Place the pulley onto the Drive Shaft with the setscrew side of the pulley facing away from
the Bearing Plate. Position the pulley so that it is as close to the lock collar as possible, but
not touching it.
Drive Shaft Lock Collar