Grain Systems Unload Augers PNEG-1421 - Manual (Page 17)

4. Installation
PNEG-1421 Direct Gear Drive Bin Sweep Auger (with Roller Wells) 17
Figure 4G 6" Tube
2. From inside the bin, insert the angle ring end of the unload tube through the hole in the bin sidewall.
NOTE: Before installing tube, remove flight from inside of tube.
Tube Size Hole Size and Location
10" 13" Hole, approximately 6" below the bin floor, inline with the center well tube.
8" 11" Hole, approximately 6-1/2" below the bin floor, inline with the center well tube.
6" 9" Hole, approximately 7-1/2" below the floor, directly inline with the center well tube.