Grain Systems Unload Augers PNEG-1421 - Manual (Page 30)

4. Installation
30 PNEG-1421 Direct Gear Drive Bin Sweep Auger (with Roller Wells)
3. Attach the pivot bracket to the left side of the gearbox using four (4) 3/8" x 3/4" flange bolts.
(See Figure 4AA.)
Figure 4AA
4. Attach a flighting section to the U-joint stub located on the gearbox. Making sure that the
Dura-Edge® side of the flight faces the center of the bin. Secure it with bolts (See Note for Bolt Size)
and stover nuts. (See Figure 4AB.)
Figure 4AB
NOTE: 6" Two (2) 7/16" x 3" bolts
8" Two (2) 1/2" x 3" bolts
10" Two (2) 1/2" x 3" bolts
(See Note for Bolt Size.)