GE Industrial Solutions Millennium II Controller J85501P-1 - Manual (Page 73)

Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008 73
Figure 6-5: Millennium Controller Connections
10. Controller Power Down
Step Action
NOTE: STOP!
Before proceeding with this step, veirify that ABS
supply (pins 93/94) and DG(pins 95/96) on the
BSL board are not connected to anything.
IF they are, perform proper transitioning
procedures and move these connections to
another source.
a. Using a fuse puller, remove all 5 controller fuses,
BEGINNING with F1. (see Figure 6-4)
b. Next, locate P6 and the Input Power, Shunt and
Regulation cable at the upper left hand corner of the
basic (BSH) controller. (see Figure 6-5)
c. Mark, Tag and Insulate this cable as Input Power.
d. Remove this connector and reposition the cable so
that it is to the right of the controller housing. The
Millennium II P6 connector is on the right side.