GE Industrial Solutions Millennium II Controller J85501P-1 - Manual (Page 93)

Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008 93
7. Remove Aux Port
Step Action
a. On the Intelligent controller (BSJ), locate P203. It
is located at the top of the BSJ board.
(see Figure 6-
10)
b.
If NO cable terminates on P203, then proceed to
the next item for removal.
If a cable terminates on P203, Mark, Tag and
Remove this cable.
c. On the Intelligent controller (BSJ), locate TB201. It
is located at the top of the BSJ board.
(see Figure 6-
10)
d.
If NO wires terminate on TB201, then proceed
to the next item for removal.
If wires terminate on TB201, Mark, Tag and
Insulate these wires and remove them. Make sure
to mark:
TB-201
Terminal
Name
1 TX+
2 TX-
3 RX+
4 RX-
8. Remove Controller Display Cable
Step Action
a. On the Intelligent controller (BSJ), locate P1. It is
located at the lower right hand corner of the BSJ
board.
b. Mark, Tag and remove this cable.