GE Industrial Solutions Millennium II Controller J85501P-1 - Manual (Page 92)

Basic Installation and User’s Guide for the Millennium II Controller
Issue 3 January 2008 92
4. Remove Modem Connections
Step Action
a. On the Intelligent controller (BSJ), locate P201. It
is located on the left hand side of the BSJ board.
(see
Figure 6-10)
b.
If NO cable terminates on P201, then proceed to
the next item for removal.
If a cable terminates on P201, Mark, Tag and
Remove this cable.
5. Remove Data Switch Cables
Step Action
a. On the Intelligent controller (BSJ), locate P205. It
is located on the left hand side of the BSJ board.
b.
If NO circuit board is connected to P205, then
proceed to the next item for removal.
If a circuit board is connected to P205, with
DB9 connectors, Mark, Tag and Remove these
cables, making note the Port numbers they are
connected to.
6. Remove PC Serial Port
Step Action
a. On the Intelligent controller (BSJ), locate P202. It
is located at the bottom of the BSJ board. (see Figure
6-10)
b.
If NO cable is connected to P202, then proceed
to the next item for removal.
If a cable is connected to P202, Mark, Tag and
Remove this cable.