Asus RX3041H - Manual (Page 51)

RX3041H User’s Manual Chapter 6. Configuring WAN Settings
37
6. Click to save the Dynamic IP settings when you are done with the configuration. You’ll
see a summary of the WAN configuration at the bottom half of the configuration page. Note that if
the default gateway address is not shown immediately, click on the WAN menu to open the WAN
configuration page again.
Figure 6.4. WAN Dynamic IP (DHCP client) Configuration Summary
6.4 Static IP
6.4.1 WAN Static IP Configuration Parameters
Table 6.3 describes the configuration parameters available for static IP connection mode.
Table 6.3. WAN Static IP Configuration Parameters
Setting Description
IP Address WAN IP address provided by your ISP.
Subnet Mask WAN subnet mask provided by your ISP. Typically, it is set as 255.255.255.0.
Gateway Address Gateway IP address provided by your ISP. It must be in the same subnet as
the WAN on the RX3041H.
Primary/ Secondary
DNS You must at least enter the IP address of the primary DNS server. Secondary
DNS is optional
6.4.2 Configuring Static IP for WAN
Follow the instructions below to configure static IP settings:
1. Open the WAN configuration page by clicking on the WAN menu.
2. Select Static from the Connection Mode drop-down list as shown in Figure
6.5.
3. Enter WAN IP address in the IP Address field. This information should be
provided by your ISP.
4. Enter Subnet Mask for the WAN. This information should be provided by your ISP. Typically, it is
255.255.255.0.