Configuring nat pool, Nat pool configuration parameters, Table 9.8. nat pool configuration parameters – Asus RX3041H User Manual
Page 92
Chapter 9. Configuring Firewall/NAT Settings
RX3041H User’s Manual
78
Source IP Type drop-down list
IP Pool drop-down list
Figure 9.29. IP Pool Example – Deny QUAKE-II Connection for MISgroup1
9.8.3
Configuring NAT Pool
9.8.3.1
NAT Pool Configuration Parameters
Table 9.8 describes the configuration parameters available for a NAT pool.
Table 9.8. NAT Pool Configuration Parameters
Field
Description
NAT Pool Name
Enter a name for the NAT Pool.
NAT Pool Type
Select the type of NAT Pool and make appropriate IP Address entries.
Static
Select this type of NAT to set a one-to-one Mapping between the Internal Address and the
External Address.
LAN IP range
For the Internal Address
Start IP
Enter the starting IP address.
End IP
Enter the ending IP address.
Internet IP Range
For the External Address
Start IP
Enter the starting IP address.
End IP
Enter the ending IP address.
Dynamic
Select this type of NAT to map a set of internal (corporate) machines to a set of public IP
addresses. Make entries for the LAN IP Range and the Internet IP Range as described above.
Overload
Select this type of NAT to use a single public IP address to connect multiple internal (corporate
LAN) machines to external (Internet) network.
NAT IP Address
Enter NAT IP address, for the overload.