Asus RX3041H - Manual (Page 89)

RX3041H User’s Manual Chapter 9. Configuring Firewall/NAT Settings
75
4. Click on the button to save the new settings. The new settings for this application filter
will then be displayed in the Application Filter List table.
9.8.1.4 Delete an Application Filter
To delete an Application Filter, click on the icon of the filter to be deleted or follow the instruction below:
1. Open the Application Filer configuration page by clicking the Firewall Î Policy List Î
Application Filter menu.
2. Select the application filter to delete. Click on the icon of the application filter to be deleted in
the Application Filter List table or select the filter type from the Filter Type drop-down list and then
select the filter rule from the Filter Rule drop-down.
3. Click on the button to delete this filter.
9.8.2 Configuring IP Pool
9.8.2.1 IP Pool Configuration Parameters
Table 9.7 describes the configuration parameters available for an IP pool.
Table 9.7. IP Pool Configuration Parameters
Field Description
IP Pool Name Enter the name of the local IP
IP Pool Type Select the type of IP Pool.
IP Range This option allows you to configure the range of IP addresses.
Start IP Enter the starting IP address of the range.
End IP Enter the ending IP address of the range.
Subnet This option allows you to include all the computers that are connected in an
IP subnet.
Subnet Address Enter the appropriate IP address.
Subnet Mask Enter the corresponding mask.
IP Address This option allows you to configure single IP address.
IP Address Enter the IP Address.
9.8.2.2 Add an IP Pool
To add an IP Pool, follow the instructions below:
1. Open the IP Pool configuration page by clicking the Firewall Î
Policy List Î IP Pool menu.
2. Select “Add New Pool” from the IP Pool drop-down list.
3. Enter a pool name into the Name field.
4. Select a pool type from the IP Pool Type drop-down list.
5. If “IP Range” pool type is selected, enter start IP address and end IP
address. If “Subnet” pool type is selected, enter subnet address and subnet mask. If “IP Address”
pool type is selected, enter an IP adderss.