Asus GigaX2048 - Manual (Page 107)

GigaX Series L2 Managed Switch User Guide
Table 7. Boot ROM commands
Command Parameters Usage Notes
d Address
[length] Dump memory contents by
giving address and length.
p NONE Display current boot parameters
g NONE
Execute firmware, enter CLI
mode
a NONE Show MAC address
b 0 or 1 or a Dual image support. You can
choose the firmware to execute
by giving a slot ID, or use “a” for
auto select. Auto-select will
execute the most updated
firmware. This is the default
setting When you fail in
firmware update, you
can use this command to
boot up the switch using
the old firmware.
Change it back to
auto-select mode after
successfully updating
the firmware.
s 0, 1, 2, 3 Set the console baud rate. 0:
9600bps 1:38400bps
2:57600bps 3:115200bps You have to set up the
terminal emulator with
the same baud rate to
make the work
x NONE Upload firmware to the switch It is slow to update
firmware by the console
port. If you lost network
connection to switch,
you can still update
firmware in this way
r NONE Toggle the safe mode When a configuration file
is corrupt or you forget
your password, use safe
mode to enter CLI mode.
Your configuration file is
lost in this mode. You
need to restore your
configuration, or
re-configure the system
w NONE Toggle administrator password
reset Reset user ID and
password once to default
value. Your configuration
settings will not be
changed.