Asus GigaX2048 - Manual (Page 92)

GigaX Series L2 Managed Switch User’s Guide
92
The Policy Edit page is used to create policy actions. The classes that
are added to a policy must have the same match type. A policy can only
have maximum 6 classes. The following fields are available:
• Class ID: select an existed Class ID.
• DSCP: select a DSCP value. Incoming packets that match the class
ID will be specified the DSCP value to the class ID
• Traffic Rate: set the traffic rate. The valid value is from 1 to 125. For
Gigabit Ethernet ports, the value will be multiplied by 8. For example,
set traffic rate to 10. Then the traffic rate of Fast Ethernet ports is 10
Mbps, but for Gigabit Ethernet ports, the traffic rate is 80Mbps.
• Traffic Burst Size: select a traffic burst size. The minimum size of
Fast Ethernet ports is 4K. For Gigabit Ethernet ports, traffic burst
size will be multiplied by 8. For example, set traffic burst size to 4K.
Then the burst size of Fast Ethernet ports is 4K Bytes, but for Gigabit
Ethernet ports, the burst size is 32K Bytes.
• Exceed Action: select exceed action. If the exceed action is not
'None', user must enter or select a value for traffic rate and traffic
burst size.
• Exceed DSCP: if exceed action is ‘DSCP’, user must select an
exceed DSCP value.