Retrieve, Show trunk – Asus GigaX2048 User Manual
Page 113
GigaX Series L2 Managed Switch User Guide
Bridge Priority (0..61440):[ old Bridge Priority] <new Bridge Priority>
[Priority]
[Path Cost]
[Edge Port]
[Point-to-point]
Displays the current STP/RSTP ports parameters setting.
CLI command: l2 stp port set
Port Settings (all,…):[all] <select a port number, or just type ‘all’ to
iteratively config>
Port <port number> Priority (0..240):[old port Priority] <new port
Priority>
Port <port number> Path Cost (1..200000000):[old port Path Cost]
<new port Path Cost>
Port <port number> EdgePort (yes/no):[old port EdgePort] <new
port EdgePort >
Port <port number> Point-to-Point (yes/no/auto):[old port
Point-to-Point]
<new port Point-to-Point >
[Retrieve]
Restores the previous saved settings from configuration file.
CLI command: l2 stp retrieve
CLI command: l2 stp bridge retrieve
CLI command: l2 stp port retrieve
[Show Trunk]
Displays a specific trunk group setting. User can create a new trunk group
by specify a unique trunk ID, a trunk name description, the port selection
criterion (rtag), LACP mode (enabled or disable), and its trunk group
member ports.
CLI command: l2 trunk show <trunk id>