3 class set – Asus GigaX2048 User Manual

Page 89

Advertising
background image

GigaX Series L2 Managed Switch User Guide

4.9.3 Class Set

This configuration page is used to create QoS classes. A class set is a
mechanism that you use to isolate a specific traffic flow (or class) from all
other traffic. The class set defines the criteria (match mode) used to match
a specific traffic flow to further classify it. The criteria can include matching
ACL rule in a Filter Set ID or DSCP list. Only one match mode and only one
ACL rule for each class set are supported. After a packet is matched
against the class-map criteria, it will be further classified through
corresponding policy set. The switch only can have 56 classes. The
following fields are available:

• Class Name: input a class name. The Class names can not be

duplicate.

• Match: select a match mode.
• Filter Set ID: if the match mode is ‘Filter’, users must select an

existed filter set ID.

• DSCP: if the match mode is ‘DSCP’, users must input DSCP values.

Click on

after you create a new class by the above information.

Then you will see the new added entry shows in the class list. Click on

to select the class that you want to modify. Editing the class, then click on

. You will see the modified entry shows in the class list. Click on

to select the class that you want to remove, then click on

to

remove it. To make the configuration effective, please go to "Save

Configuration" page, then click on

.

Advertising
This manual is related to the following products: