Asus GigaX2048 User Manual
Page 27
GigaX Series L2 Managed Switch User Guide
Default User Name:
admin
Default Password:
(no password)
You can change the password at any time (see section
5.3.1 System Commands).
3. To setup a new IP address, click “System”, then “IP Setup” (see
Figure 8). Fill in the IP address, network mask and default gateway,
then click
.
4. If your new address is different from the default, the browser can not
update the switch status window or retrieve any page. This is
normal. You have to retype the new IP address in the
address/location box, and press <Enter>. The WEB link returns.
5. To enable authentication for Web access, click “Administration” on
the menu list, then select “Enabled” to start the protection.
Note that the GigaX 2048 and 2024 models have the
same web interface, except for the front panel image on
top of the screen (see figures on the next page).
The following sections show only one screen image (that
of the GigaX 2048 model) if the screen contents for both
models are the same. Both the GigaX 2048 and 2024
screens are shown when the screen contents are
different.
A login window appears immediately after you click
. See the
figures on the next page.